EAW VR62 Manuel d'instructions télécharger pdf (Page 6)

6 – VR61 and VR62

VR61 and VR62 – 7

Mounting Instructions

1. Remove the screw from each end of the enclosure as shown below.

2. Align the bracket slots with the mounting holes on each end of the enclosure. Make

sure the four openings in the bracket arms face upward.

3. Onto each of the two supplied hex-head screws, place a lock washer, and a at

washer. Thread them at least three complete turns into both of the enclosure’s side

mounting holes, and tighten them securely.

4. The bracket /enclosure assembly may be mounted vertically or horizontally.

5. The enclosure may be adjusted to any angle by loosening the 2 hex-head screws,

turning the enclosure to the desired angle, and then re-tightening the screws.

SCREW 1/4 INCH-20

X 1.25 INCH LONG

HEX HEAD

2 PLACES

1/4 INCH FLAT WASHER

2 PLACES

1/4 INCH LOCK

WASHER

2 PLACES

BRACKET/WALLMOUNT

REMOVE SCREWS

FROM BOTH SIDES

VR62

VR61

MOUNTING POINT

1/4-20 THREADED HOLE

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

EAW VR62 Manuel d'instructions Page 6